mirror of
https://github.com/Klipper3d/klipper.git
synced 2025-10-26 00:36:08 +02:00
50cb362234
Normally the toolhead code will flush the lookahead buffer every ~250ms and will briefly pause to avoid buffering too much data. That pause allows other tasks to run. Make sure to periodically yield to other tasks on each lookahead buffer flush even if a delay isn't needed. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Welcome to the Klipper project!
The Klipper firmware controls 3d-Printers. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use the Klipper software.
Start by installing Klipper software.
Klipper software is Free Software. See the license or read the documentation. We depend on the generous support from our sponsors.