Deploying to gh-pages from @ Klipper3d/klipper@e24ea3652c 🚀

Config_Reference.html

@@ -8542,7 +8542,7 @@ for full functionality.</p>
 Octoprint as they will conflict, and 1 will fail to initialize
 properly likely aborting your print.</p>
 <p>If you use Octoprint and stream gcode over the serial port instead of
-printing from virtual_sd, then remo <strong>M1</strong> and <strong>M0</strong> from <em>Pausing commands</em>
+printing from virtual_sd, then remove <strong>M1</strong> and <strong>M0</strong> from <em>Pausing commands</em>
 in <em>Settings &gt; Serial Connection &gt; Firmware &amp; protocol</em> will prevent
 the need to start print on the Palette 2 and unpausing in Octoprint
 for your print to begin.</p>