Deploying to gh-pages from @ Klipper3d/klipper@4a92727eab 🚀

Config_Reference.html

@@ -5562,6 +5562,9 @@ z_offset:
 sensor_type: ldc1612
 #   The sensor chip used to perform eddy current measurements. This
 #   parameter must be provided and must be set to ldc1612.
+#intb_pin:
+#   MCU gpio pin connected to the ldc1612 sensor's INTB pin (if
+#   available). The default is to not use the INTB pin.
 #z_offset:
 #   The nominal distance (in mm) between the nozzle and bed that a
 #   probing attempt should stop at. This parameter must be provided.