Deploying to gh-pages from @ Klipper3d/klipper@329fbd01d8 🚀

Pressure_Advance.html

@@ -1427,7 +1427,7 @@ running the test.</p>
 <a href="prints/square_tower.stl">docs/prints/square_tower.stl</a>. Use a high
 speed (eg, 100mm/s), zero infill, and a coarse layer height (the layer
 height should be around 75% of the nozzle diameter). Make sure any
-"dynamic acceleration control" is disabled in the slicer.</p>
+"dynamic acceleration control" and "scarf joint" seams are disabled in the slicer.</p>
 <p>Prepare for the test by issuing the following G-Code command:</p>
 <div class="highlight"><pre><span></span><code>SET_VELOCITY_LIMIT SQUARE_CORNER_VELOCITY=1 ACCEL=500
 </code></pre></div>