test/klippy/z_tilt.test

# Test case for z_tilt and quad_gantry_level
CONFIG z_tilt.cfg
DICTIONARY atmega2560.dict

# Start by homing the printer.
G28
G1 Z5 X10 Y10 F6000
M400
GET_POSITION

# Run Z_TILT_ADJUST in manual mode
Z_TILT_ADJUST METHOD=MANUAL
G1 Z2.909972
ACCEPT
G1 Z2.924972
ACCEPT
G1 Z2.959972
ACCEPT
G1 Z2.924972
ACCEPT

# Report position
G1 Z5 X10 Y10 F6000
M400
GET_POSITION

# Run again in automatic mode
Z_TILT_ADJUST
test: Add quad_gantry_level and z_tilt_adjust test cases Signed-off-by: Kevin O'Connor <kevin@koconnor.net> 2019-06-12 13:49:27 -04:00			`# Test case for z_tilt and quad_gantry_level`
			`CONFIG z_tilt.cfg`
			`DICTIONARY atmega2560.dict`

			`# Start by homing the printer.`
			`G28`
			`G1 Z5 X10 Y10 F6000`
test: Flush moves in quad_gantry_level and z_tilt_adjust tests Signed-off-by: Kevin O'Connor <kevin@koconnor.net> 2019-06-12 15:36:32 -04:00			`M400`
test: Add quad_gantry_level and z_tilt_adjust test cases Signed-off-by: Kevin O'Connor <kevin@koconnor.net> 2019-06-12 13:49:27 -04:00			`GET_POSITION`

			`# Run Z_TILT_ADJUST in manual mode`
			`Z_TILT_ADJUST METHOD=MANUAL`
			`G1 Z2.909972`
			`ACCEPT`
			`G1 Z2.924972`
			`ACCEPT`
			`G1 Z2.959972`
			`ACCEPT`
			`G1 Z2.924972`
			`ACCEPT`

			`# Report position`
			`G1 Z5 X10 Y10 F6000`
test: Flush moves in quad_gantry_level and z_tilt_adjust tests Signed-off-by: Kevin O'Connor <kevin@koconnor.net> 2019-06-12 15:36:32 -04:00			`M400`
test: Add quad_gantry_level and z_tilt_adjust test cases Signed-off-by: Kevin O'Connor <kevin@koconnor.net> 2019-06-12 13:49:27 -04:00			`GET_POSITION`

			`# Run again in automatic mode`
			`Z_TILT_ADJUST`