test/klippy/screws_tilt_adjust.test

# Test case for bed screws tilt helper tool
CONFIG screws_tilt_adjust.cfg
DICTIONARY atmega2560.dict

# Simple script to test
G28
SCREWS_TILT_CALCULATE
SCREWS_TILT_CALCULATE MAX_DEVIATION=0.01
screws_tilt_adjust: Add new screws_tilt_adjust tool (#1367) Signed-off-by: Rui Caridade <rui.mcbc@gmail.com> 2019-03-08 16:47:17 +00:00			`# Test case for bed screws tilt helper tool`
			`CONFIG screws_tilt_adjust.cfg`
test: Rename atmega2560-16mhz.config to atmega2560.config There's no need to include the 16mhz as basically all atmega chips are run at 16mhz. Signed-off-by: Kevin O'Connor <kevin@koconnor.net> 2019-03-22 12:36:18 -04:00			`DICTIONARY atmega2560.dict`
screws_tilt_adjust: Add new screws_tilt_adjust tool (#1367) Signed-off-by: Rui Caridade <rui.mcbc@gmail.com> 2019-03-08 16:47:17 +00:00
			`# Simple script to test`
			`G28`
			`SCREWS_TILT_CALCULATE`
screws_tilt_adjust: Add MAX_DEVIATION parameter for bed level invariant. This is useful when a saved bed mesh is used to ensure that the bed level has not drifted too far from where it was when the mesh was created. Signed-off-by: Johannes Stuettgen <johannes.stuettgen@gmail.com> 2021-02-08 17:52:46 +01:00			`SCREWS_TILT_CALCULATE MAX_DEVIATION=0.01`