test/klippy/manual_stepper.cfg

# Test config for manual_stepper
[manual_stepper basic_stepper]
step_pin: ar54
dir_pin: ar55
enable_pin: !ar38
step_distance: .0125
velocity: 7
accel: 500

[manual_stepper homing_stepper]
step_pin: ar60
dir_pin: !ar61
enable_pin: !ar56
step_distance: .0125
endstop_pin: ^ar14

[mcu]
serial: /dev/ttyACM0
pin_map: arduino

[printer]
kinematics: none
max_velocity: 300
max_accel: 3000
manual_stepper: Add an "extras" module for manually controlling a stepper Signed-off-by: Kevin O'Connor <kevin@koconnor.net> 2019-02-08 20:11:05 -05:00			`# Test config for manual_stepper`
			`[manual_stepper basic_stepper]`
			`step_pin: ar54`
			`dir_pin: ar55`
			`enable_pin: !ar38`
			`step_distance: .0125`
manual_stepper: Add support for moves with acceleration Signed-off-by: Kevin O'Connor <kevin@koconnor.net> 2019-03-03 13:23:45 -05:00			`velocity: 7`
			`accel: 500`
manual_stepper: Add an "extras" module for manually controlling a stepper Signed-off-by: Kevin O'Connor <kevin@koconnor.net> 2019-02-08 20:11:05 -05:00
			`[manual_stepper homing_stepper]`
			`step_pin: ar60`
			`dir_pin: !ar61`
			`enable_pin: !ar56`
			`step_distance: .0125`
			`endstop_pin: ^ar14`

			`[mcu]`
			`serial: /dev/ttyACM0`
			`pin_map: arduino`

			`[printer]`
			`kinematics: none`
			`max_velocity: 300`
			`max_accel: 3000`