klippy/extras/heater_generic.py

# Support for a generic heater
#
# Copyright (C) 2019  John Jardine <john@gprime.net>
#
# This file may be distributed under the terms of the GNU GPLv3 license.

def load_config_prefix(config):
    pheaters = config.get_printer().try_load_module(config, 'heaters')
    return pheaters.setup_heater(config)
Generic Heater Support Adds the ability to register a custom/generic heater through a new extra called heater_generic. This takes a gcode_id that is reported by M105. Adds a new command to set the temperature for any heater using the syntax: SET_HEATER_TEMPERATURE HEATER=<heater_name> TARGET=<target_temp> Signed-off-by: John Jardine <john@gprime.net> 2019-02-14 01:15:11 +00:00			`# Support for a generic heater`
			`#`
			`# Copyright (C) 2019 John Jardine <john@gprime.net>`
			`#`
			`# This file may be distributed under the terms of the GNU GPLv3 license.`

			`def load_config_prefix(config):`
heaters: Make heater.py an "extras" module The heater logic is an independent module that does not need to be treated as part of the "core" klipper code. Signed-off-by: Kevin O'Connor <kevin@koconnor.net> 2020-04-25 13:27:41 -04:00			`pheaters = config.get_printer().try_load_module(config, 'heaters')`
			`return pheaters.setup_heater(config)`